ABB i-bus KNX Product Manual page 80

®
ABB i-bus KNX
© 2008 ABB STOTZ-KONTAKT GmbH
Commissioning
Brightness value or preset or scene recall
Options: no reaction
Slave mode can be deactivated
If the slave mode is running, this parameter can be used to define the
reaction to a brightness value (receipt of a telegram on the object Brightness
value or preset or scene recall) (receipt of a telegram on one of the objects
Preset... or 8 bit scene).
•
no reaction: With active slave mode Brightness value or preset or scene
recall does not produce a reaction.
The commands are ignored.
•
Slave mode can be deactivated: With activated slave mode this is ended
with a Brightness value or preset or scene recall and the commands are
executed. The slave more is latent and waits until a renewed activation
via the object Activate slave mode.
Slave mode after bus voltage recovery
Options: active
inactive
This parameter defines if slave mode is active or inactive after bus voltage
recovery. If the slave function is active, the brightness value on the object
Brightness value of slave is recalled and set after bus voltage recovery.
Note
Parameterisation in parameter window
In this window you can set that an ON command (switch object is written
with the value 1) for the output is initiated after bus voltage recovery. If in
the parameter window
is parameterised as active, and at the same time the reaction of the slave
mode is parameterised as deactivated at switch on, the slave is
immediately deactivated again by an ON command.
This means that the effect on the parameter Value of object "Switch" on
bus voltage recovery (X: General) has a higher priority than the effect of
the parameter Slave mode after voltage recovery described here.
If in the parameter window
a slave and if the outputs are parameterised individually, a further parameter
appears:
X: General:
the slave mode after bus voltage recovery
X: Slave
the output has been parameterised as
X: General
78