Parameter Window X: Control Operating - ABB i-bus KNX Product Manual

®
ABB i-bus KNX
3.2.13 Parameter window
X: Control Operating
© 2008 ABB STOTZ-KONTAKT GmbH
Commissioning
The parameter window X: Control Operating is enabled if in parameter
window the parameter Select additional function is selected with
X: General
the option Light control. As it is a default setting here this parameter page
always remains visible in the control mode.
In this parameter window the response of the light control to the switch, dim,
brightness, scene or preset command is defined.
The Light control is activated by an ON command (receipt of a telegram with
the value 1 on the object Switch or Switch/Status). An OFF command
always causes switch off of the lighting and the light control. The light control
is in standby mode and recommences with light control via an ON command
or when a telegram with the value 1 is again received on the activate control
object.
72