Supplied State; Maintenance And Cleaning - ABB i-bus KNX Product Manual

®
ABB i-bus KNX
2.9

Supplied state

2.10 Maintenance and
cleaning
© 2008 ABB STOTZ-KONTAKT GmbH
Device technology
The Light Controllers are delivered with the physical address 15.15.255.
The load connection terminals and the relay are open and the bus terminal
is fitted.
Please note that vibration during transport can change the relay settings.
The contact position can be recognised at any time on the device by a visual
inspection and can be changed if necessary by a manual operation.
The application program Control Dim xf 1-10V/1 (x = 2 or 4, number of
outputs) is preloaded.
The Light Controller and Light Sensor are maintenance free. No repairs
should be carried out by unauthorised personnel if damage occurs, e.g.
during transport and/or storage.
The warranty expires if the device is opened.
If devices become dirty, e.g. the cover of the Light Sensor, it can be cleaned
using a dry cloth. Should a dry cloth not remove the dirt, the devices can be
cleaned using a slightly damp cloth and soap solution. Corrosive materials or
solvents should never be used.
In order to avoid negative influence on the brightness detection it is
necessary to be very careful when cleaning the rods of the Light Sensor.
22