®
ABB i-bus
KNX
3.2.7
Parameter window
X: Value
© 2008 ABB STOTZ-KONTAKT GmbH
Commissioning
In this parameter window it is possible to define a brightness value via
the 1 byte object Brightness value.
Time for passing from 0...100 % while
setting brightness, in s [0...65,535]
Options:
0...65,535
This parameter determines the speed with which the device dims to a new
brightness value. The speed is set which is required to dim from 0...100 %.
Maximum brightness value
Options:
100/99...51/50 %
This parameter defines the maximum brightness value, which can control
the output via a brightness telegram. The value limit which is used to set
a brightness value with the preset and scene function is considered.
The limit in slave operation is also active here.
If a brightness value which is greater than the maximum brightness value
is received, the output sets the maximum brightness value. This value
is reported back on the bus.
The limit value is independent of the:
•
Dimming value which is parameterised in the parameter window
and which applies for the dimming, switching and
X: Dimming
staircase lighting function.
•
Control limit which is parameterised in the parameter window
and which applies during lighting control.
X: Control
49