Assembly And Installation - ABB i-bus KNX Product Manual

®
ABB i-bus KNX
2.3 Assembly and
installation
© 2008 ABB STOTZ-KONTAKT GmbH
Device technology
The ABB i-bus Light Controllers LR/S x.16.1 are suitable for installation in
the distribution board or small enclosures for fast installation on 35 mm
mounting rails to DIN EN 60 715.
The mounting position of the Light Controller can be selected as required
and no auxiliary voltage is required. The device is supplied with power via
the KNX.
Danger
Accessibility to the device for the purpose of operation, testing,
visual inspection, maintenance and repair must be must be provided
(DIN VDE 0100-520).
The voltage supply to the device must be switched off before mounting
work is performed.
The installation and commissioning may only be carried out by electrical
specialists. The appropriate norms, guidelines, regulations and
specifications should be observed when planning and setting up
electrical installations.
The electrical connection is implemented using screw terminals. The
connection to the KNX is established using a bus connection terminal.
The terminal designation is located on the housing.
The devices should be protected from damp, dirt and damage during
transport, storage and operation.
Important
The device should only be operated in a closed housing, e.g. distribution
board.
The devices should not be operated outside the specified technical data
range.
The Light Sensor LF/U 2.1 is optimised for ceiling installation in a
commercially available 60 mm flush mounted box. The brightness detection
can be influenced with the enclosed fibre-optic rods. The detection range
should be taken from the
The luminaries may not shine directly onto the brightness sensor. Pay
attention to unfavourable reflections, e.g. from mirrored or glass surfaces.
polar diagram.
19