Parameters - ABB i-bus KNX Product Manual

®
ABB i-bus KNX
3.2

Parameters

© 2008 ABB STOTZ-KONTAKT GmbH
Commissioning
This chapter describes the parameters of the Light Controller using the
parameter window. The parameter window features a dynamic structure
so that further parameters or whole parameter windows may be enabled
depending on the parameterisation and the function of the outputs.
In the following description Output X represents all outputs of the Light
Controller. It is possible to program commonly for all outputs or for
each one individually.
Note
Ensure when changing between individual and common parameterisation
of the parameters that the parameterisation settings and group addresses
for the objects already implemented are not accepted.
The individual parameter window and the parameter window for all outputs
only differ in the designation of their outputs.
For this reason only parameter windows for common programming X... are
described. Here X is used to represent A-B for a 2-fold lighting control and
A-D for a 4-fold lighting control.
The parameter windows for outputs A, B, C or D are identical.
The default values of the parameters are underlined,
e.g.
Option: yes
no.
Indented parameter descriptions indicate that this parameter is only visible
when the main parameter is parameterised accordingly.
The illustrations of the parameter windows in this manual correspond to the
ETS3 parameter windows. The user program is optimised for ETS3. Using
the corresponding *.VD2 file it is also possible to parameterise and engineer
the Light Controller without problems using ETS2. In the ETS2 it is possible
however, that the parameter window is automatically split by the ETS user
interface if all parameters are used.
If in the following the object Switch or Brightness value is mentioned,
they also apply for the objects Switch/Status or Brightness value/Status.
26