Siemens SIMATIC ET 200SP Manual page 96

Parameters/address space
4.6 Declaration of parameters
Response to residual current detection
You use this device parameter to specify how the motor starter is to respond to residual
current detection.
You will find more information in Chapter "Response to residual current detection (Page 52)".
Response to asymmetry
You use this device parameter to determine how the motor starter is to behave in the event
of asymmetry.
You will find more information in Chapter "Asymmetry monitoring (Page 61)".
Group fault diagnostics
You use this parameter to determine whether diagnostics via PROFINET or PROFIBUS DP
(fault type) are enabled or disabled.
You will find more information in Chapter "Group fault diagnostics/group warning diagnostics
(Page 64).
Group warning diagnostics
You use this device parameter to determine whether or not a maintenance alarm is
forwarded to the higher-level CPU.
You will find more information in Chapter "Group fault diagnostics/group warning diagnostics
(Page 64).
Input n signal
You use this device parameter to determine whether or not the input level of the digital inputs
is to be saved.
You will find more information in Chapter "Inputs (Page 65)".
Input n level
You use this device parameter to specify the input logic.
You will find more information in Chapter "Inputs (Page 65)".
Input n action
Different actions can be triggered when an input signal is present.
You can find out which actions you can parameterize depending on "Input n level", "Input n
signal" and "Mode" in Chapter Inputs (Page 65).
96
Motor starter (3RK1308-0**00-0CP0)
Manual, 12/2016, A5E34821005002A/RS-AB/002