Siemens SIMATIC ET 200SP Manual page 89

Behavior during the firmware update
Note the following behavior during the firmware update of the motor starter:
● The LEDs flash as described in chapter "Status and error displays (Page 109)".
● The motor starter powers up again after completion of the firmware update. Diagnoses
are reset. The firmware update does not affect the TMM and the cooling time.
● The sensor supply of the DI module remains active.
Behavior after the firmware update
After the firmware update, check the firmware version of the updated module. A successfully
loaded firmware update is activated immediately.
If a fail-safe motor starter is in "Manual local" mode during the firmware update, the motor
starter switches to commissioning mode after the successful firmware update operation. You
must first confirm ATEX parameters before you can perform manual local control.
Reference
You can find more information on the procedure in the STEP 7 online help.
See also
Commissioning mode (Page 92)
Configuring ATEX operation (Page 100)
Motor starter (3RK1308-0**00-0CP0)
Manual, 12/2016, A5E34821005002A/RS-AB/002
Product overview
3.7 Functions
89