Siemens SIMATIC ET 200SP Manual page 125

The supported object numbers and their meaning are shown in the table below:
Table A- 3
Object No. Event messages
327
337
340
351
365
366
1539
1541
1542
310
357
359
376
378
454
1520
1580
±: Event is entered as "incoming" (+) and "outgoing" (-) event. Other messages are entered only as
"incoming" messages
Motor starter (3RK1308-0**00-0CP0)
Manual, 12/2016, A5E34821005002A/RS-AB/002
Assignment of object number to event message
Thermal motor model overload
Residual current detected
± Asymmetry detected
Input warning
Invalid parameter value
Parameters cannot be changed in ON state
Warning limit - motor heating exceeded
± I -warning limit exceeded
e
± I -warning limit undershot
e
± Emergency start active
Automatic mode
Manual local mode
Firmware update successful
Firmware update has errors
Internal communication fault
± Energy-saving mode active
Switching element hot
A.4 DS75 logbook - Read events
Comment
Warnings
In the case of a group fault, the message
"Motor overload trip" is also queued.
-
-
-
Not in the case of startup since it is a
group fault
-
-
-
-
Actions
-
Enter at the time of changeover
Enter at the time of changeover
-
-
-
-
-
Data sets
125