Delta Electronics AFE075A43A User Manual page 85

Ambient Temperature Warning Level
Settings 0.0~11.0℃

Numbers of Fault Retry
Settings 0～10

After fault occurs (only for over-current OC or over-voltage OV fault occurs and occ), the
AFE2000 unit can be reset/restarted automatically up to 10 times. Setting this parameter
to 0 will disable to reset/restart the operation after any fault has occurred.
Fault Retry Reset Time
Settings 1~600 sec

Fan Control
Settings
 This parameter sets the fan control method for dissipating the heat. (For Frame B, only ON/OFF
control is available.)
Voltage Boosting Error (Level)
Settings 0.0～15.0V
Voltage Boosting Error (Time)
Settings 0.0~10.0sec

If the detected DC Bus feedback value minus the DC Bus command value is greater than the
setting in Pr.03-08 and for a period longer than Pr.03-09, then Voltage Boosting Error (BST) would
arise.
Chapter 11 Description of Parameter SettingsAFE2000 Series
0: Fan is always ON
1: As the drive stops, the fan will continue to run for 60 sec then stop.
2: Fan stops when the drive stops operation
3: Fan ON/OFF depends on the ambient temperature
4: Fan is always OFF
11-83
Factory Setting:
60.0
Factory Setting: 0
Factory Setting: 600
Factory Setting: 0
Factory Setting: 5.0
Factory Setting: 5.0