Delta Electronics AFE075A43A User Manual page 54

Chapter 7 Option CardsAFE2000 Series
Environment
Noise immunity
Operation/storage
Vibration/shock
immunity

Installation
Connecting CMC-EIP01 to Network
1. Turn off the AFE2000 power.
2. Open up AFE2000 cover.
3. Connect CAT-5e network cable to RJ-45 port on CMC-EIP01
(See Figure 2).
RJ-45 PIN Definition
PIN Signal
1 Tx+
2 Tx-
3 Rx+
4 --

Connecting CMC-EIP01 to AFE2000
1. Turn off the AFE2000 power.
2. Open up AFE2000 cover.
3. Place the insulation spacer into the positioning pin at Slot 1 (shown in Figure 3), and aim the two holes on
the PCB at the positioning pin. Press the pin to clip the holes with the PCB (see Figure 4).
4. Screw up at torque 6 ~ 8 kg-cm (5.21 ~ 6.94 in-lbs) after the PCB is clipped with the holes (see Figure 5).
ESD (IEC 61800-5-1,IEC 61000-4-2)
EFT (IEC 61800-5-1,IEC 61000-4-4)
Surge Test (IEC 61800-5-1,IEC 61000-4-5)
Conducted Susceptibility Test (IEC 61800-5-1,IEC 61000-4-6)
Operation: -10°C ~ 50°C (temperature), 90% (humidity)
Storage: -25°C ~ 70°C (temperature), 95% (humidity)
International standard: IEC 61800-5-1, IEC 60068-2-6/IEC 61800-5-1, IEC 60068-2-27
Definition PIN
Positive pole for
5
data transmission
Negative pole for
6
data transmission
Positive pole for
7
data receiving
N/C 8
[Figure 2]
Signal Definition
-- N/C
Negative pole for
Rx-
data receiving
-- N/C
-- N/C
7-52