Verifying Clocking For Acr On Aps Ct3-T1 In Cesopsn - Cisco ASR 900 Series Configuration Manual

Configuring SONET
t1 1 clock source recovered 1
end
To configure the recovered clock with priority 1, use the following commands:
enable
configure terminal
recovered-clock acr 200
clock recovered 1 adaptive cem 1 priority 1
end
To configure clock source in CT3 mode of STS-1 for CESoPSN, use the following commands:
enable
configure terminal
controller sonet 0/4/6
sts-1 1
mode ct3
t1 1 clock source recovered 1
end
To configure the recovered clock with priority 2, use the following commands:
enable
configure terminal
recovered-clock acr 200
clock recovered 1 adaptive cem 2 priority 2
end

Verifying Clocking for ACR on APS CT3-T1 in CESoPSN

Use the show recovered-clock command to verify the ACR on APS in CT3 mode for CESoPSN:
Router#show recovered clock
Recovered clock status for SONET-ACR 200
----------------------------------------
Clock
Priority
1
1
4
1
Configuring Clocking for DCR on APS CT3-T1 in CESoPSN
For clocking, you need to configure Sonet controllers with prriority.
To configure clock source in CT3 mode of STS-1 for CESoPSN, use the following commands:
enable
configure terminal
controller mediatype 0/3/6
mode sonet
rate oc3
sts-1 1
mode ct3
t1 1 clock source recovered 1
end
To configure CEM interface, use the following commands:
interface cem <bay>/<slot>/<port>
Type Mode
OCx-T1 ADAPTIVE 1
OCx-T1 ADAPTIVE 38
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x (Cisco
Verifying Clocking for ACR on APS CT3-T1 in CESoPSN
CEM Status Circuit-No
ACQUIRED 200/1/1(acr/t3/t1)
ACQUIRING 200/3/1/1(acr/path/vtg/t1)
Working Protect
ACQUIRED ACQUIRED
ACQUIRIN ACQUIRING
ASR 900 Series)
61