Configuring Msp For Cesopsn - Cisco ASR 900 Series Configuration Manual

Configuring MSP on 1-Port OC192/STM-64 or 8-Port OC3/12/48/STM-1/-4/-16 Module
Egress Pkts:
CEM Counter Details
Input Errors:
Pkts Missing:
Misorder Drops:
Error Sec:
Unavailable Sec: 0
Pkts Malformed:
Generated Lbits: 0
Generated Rbits: 0
Generated Nbits: 10950
Generated Pbits: 0
Device#

Configuring MSP for CESoPSN

This section describes the configuration of MSP for CESoPSN.
Configuring CEM Group for MSP on Virtual ACR AU3-T1 in CESoPSN
To configure CEM group on MSP, use the following commands:
enable
configure terminal
controller sdh-acr 200
aug mapping au-3
au-3 1
mode vc1x
Tug-2 1 payload vc11
T1 1 cem-group 0 timeslots 1 - 7
To configure the working controller, use the following commands:
enable
configure terminal
controller sdh 0/3/6
au-3 1
Tug-2 1 payload vc11
vc 1 overhead v5 2
To configure the protect controller, use the following commands:
enable
configure terminal
controller sdh 0/4/6
au-3 1
Tug-2 1 payload vc11
vc 1 overhead v5 2
Verifying CEM Group for MSP on Virtual ACR AU3-T1 in CESoPSN
This section includes show command to verify CEM Group for MSP on Virtual ACR AU3-T1 in CESoPSN:
Router# show cem circuit interface cem-acr 1
CEM-ACR1, ID: 0, Line: UP, Admin: UP, Ckt: ACTIVE
Path Mode : VC1X,Payload:VC11, AU3: 1, TUG-2: 1, T1: 1,CEM Mode: T1-CESoP
Controller state: up, T1/E1 state: up
Idle Pattern: 0xFF, Idle CAS: 0x8
Dejitter: 6 (In use: 0)
Payload Size: 192
Framing: Framed (DS0 channels: 1-24)
CEM Defects Set
111851778
0
0
0
0
0
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x (Cisco
Dropped: 0
Output Errors: 0
Pkts Reordered: 0
JitterBuf Underrun: 0
Severly Errored Sec: 0
Failure Counts: 0
JitterBuf Overrun: 0
Received Lbits: 0
Received Rbits: 0
Received Nbits: 9093
Received Pbits: 0
Configuring MSP for CESoPSN
ASR 900 Series)
119