Verifying Clocking Dcr For Msp Au3-T1 In Cesopsn - Cisco ASR 900 Series Configuration Manual

Configuring MSP on 1-Port OC192/STM-64 or 8-Port OC3/12/48/STM-1/-4/-16 Module

Verifying Clocking DCR for MSP AU3-T1 in CESoPSN

Use the show recovered-clock command to verify the DCR for AU3-T1 in CESoPSN:
Router# show recovered-clock
Recovered clock status for MSP-DCR 200
----------------------------------------
Clock
Priority
5
1
Configuring Clocking ACR for MSP AU4-E1 in CESoPSN
To configure clock source on MSP for the working controller, use the following commands:
enable
configure terminal
controller sdh 0/3/6
au-4 1
tug-3 1
tug-2 1 payload vc12
e1 1 clock source recovered 5
end
To configure the recovered clock, use the following commands:
enable
configure terminal
recovered-clock acr 200
clock recovered 5 adaptive cem 1 priority 1
end
To configure clock source on MSP for the protect controller, use the following commands:
enable
configure terminal
controller sdh 0/4/6
au-4 1
tug-3 1
tug-2 1 payload vc12
e1 1 clock source recovered 5
end
To configure the recovered clock, use the following commands:
enable
configure terminal
recovered-clock acr 200
clock recovered 5 adaptive cem 2 priority 2
end
Verifying Clocking ACR for MSP AU4-E1 in CESoPSN
Use the show recovered-clock command to verify the ACR for AU4-E1 in CESoPSN:
Router# show recovered-clock
Recovered clock status for MSP-ACR 200
----------------------------------------
Clock
Priority
4
Type Mode
OCx-T1 DIFFERENTIAL 44
Type Mode
OCx-T1 ADAPTIVE 38
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x (Cisco
Verifying Clocking DCR for MSP AU3-T1 in CESoPSN
CEM Status Circuit-No
ACQUIRING 200/4/1/1(acr/path/vtg/t1) ACQUIRING
CEM Status Circuit-No
ACQUIRING 200/3/1/1(acr/path/vtg/t1) ACQUIRING
Working Protect
ACQUIRING
Working Protect
ACQUIRING
ASR 900 Series)
123