16-Port T1/E1 Interface Module (A900-Ima16D) - Cisco ASR 907 Hardware Installation Manual

Cisco ASR 907 Router Overview
Figure 13: A900-IMA8CS1Z-M Gigabit Ethernet Interface Module
The following modes are supported for the Interface Module, based on slot capacity:
• 8 x 1GigE (SFP) Fully subscribed mode (FS)
• 8 x 1GigE (SFP) + 1 x 10GigE (SFP+) Fully subscribed mode (FS)
• 16 x 1GigE (C-SFP) + 1 x 10GigE (SFP+) Fully subscribed mode (FS)
• 16 or 18 x 1GigE (C-SFP) Oversubscribed mode (OS)
• 16 x 1GigE (C-SFP) + 1 x 10GigE (SFP+) Oversubscribed mode (OS)
• 8 or 9 x 1GigE (SFP) Fully subscribed mode (FS)
• 1 x 10GigE (SFP+) Fully subscribed mode (FS)
For information on supported SFP modules, see
Sheet.
For more information on port numbering, see Configuring 1-port 10 Gigabit Ethernet (1 X SFP+) / 1-port
Gigabit Ethernet (1 X SFP) / 2-port Gigabit Ethernet (1 X CSFP) and 16-port Gigabit Ethernet (8 X CSFP)
/ 8-port Gigabit Ethernet (8 X SFP) Interface Module chapter of the Cisco ASR 900 Router Series Configuration
Guide, Cisco IOS XE Everest 16.6.1.

16-Port T1/E1 Interface Module (A900-IMA16D)

The 16-port T1/E1 interface module provides connectivity for up to 16 T1/E1 ports through a 100-pin Amplimite
connector. The 16-port T1/E1 interface module requires the use of a patch panel to provide RJ48 (T1) or BNC
(E1) connectors. The figure below shows the interface module.
16-Port T1/E1 Interface Module (A900-IMA16D)
Cisco ASR 900 Series Aggregation Services Routers Data
Cisco ASR 907 Router Hardware Installation Guide
21