Configuring Cem Group For Cesopsn - Cisco ASR 900 Series Configuration Manual

Configuring SDH on 1-Port OC-192/STM-64 or 8-Port OC-3/12/48/STM-1/-4/-16 Module

Configuring CEM Group for CESoPSN

Configuring CEM Group for AU3-T1 on SDH for CESoPSN
To configure MediaType controller and rate on SDH port, use the following commands:
enable
configure terminal
controller mediatype 0/5/0
mode sdh
controller sdh 0/5/0
rate stm1
end
To configure CEM group for AU3-T1 on SDH for CESoPSN, use the following commands:
enable
configure terminal
controller sdh 0/5/0
aug mapping au-3
au-3 1
mode vc1x
Tug-2 1 payload vc11
T1 1 cem-group 0 timeslots 1 - 7
T1 1 framing esf
vc 1 overhead v5 2
end
Verifying CEM Group for AU3-T1 on SDH for CESoPSN
This section includes show command to verify CEM Group for AU3-T1 on SDH for CESoPSN:
Router# show cem circuit interface cem 0/5/0
sdh0/5/0, ID: 0, Line: UP, Admin: UP, Ckt: ACTIVE
Path Mode : VC1X,Payload:VC11, AU3: 1, TUG-2: 1, T1: 1,CEM Mode: sdh-CESoP
Controller state: up, T1/E1 state: up
Idle Pattern: 0xFF, Idle CAS: 0x8
Dejitter: 6 (In use: 0)
Payload Size: 56
Framing: Framed (DS0 channels: 1-7)
CEM Defects Set
None
Signalling: No CAS
RTP: No RTP
Ingress Pkts:
Egress Pkts:
CEM Counter Details
Input Errors:
Pkts Missing:
Misorder Drops:
Error Sec:
Unavailable Sec: 0
Pkts Malformed:
Generated Lbits: 0
Generated Rbits: 868
Generated Mbits: 146392
54113124
54112259
0
868
0
0
0
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x (Cisco
Configuring CEM Group for CESoPSN
Dropped: 0
Dropped: 0
Output Errors: 0
Pkts Reordered: 0
JitterBuf Underrun: 869
Severly Errored Sec: 0
Failure Counts: 28
JitterBuf Overrun: 0
Received Lbits: 0
Received Rbits: 1830
Received Mbits: 232588
ASR 900 Series)
105