Sdh Multiplexing - Cisco ASR 900 Series Configuration Manual

Configuring SDH on 1-Port OC-192/STM-64 or 8-Port OC-3/12/48/STM-1/-4/-16 Module
SDH Circuits
Configuring (AU-3) VC-3—TUG-2—VC-12—T1
circuit
Configuring (AU-3) VC-3—TUG-2—VC-12 circuit
Configuring (AU-3) VC-3—TUG-2—VC11 circuit
Configuring (AU-3) VC-3—TUG-2—VC11—E1
circuit

SDH Multiplexing

The terms and definitions of SDH multiplexing principles are:
• Mapping – A process used when tributaries are adapted into VCs by adding justification bits and Path
• Aligning – This process takes place when a pointer is included in a Tributary Unit (TU) or an
Overhead (POH) information.
Administrative Unit (AU), to allow the first byte of the VC to be located.
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x (Cisco
Configuration Details
• Configuring Mediatype Controller
• Configuring Rate on SDH Ports
• Configuring AU-3 or AU-4 Mapping
• Configuring Mode VC-1x
• Configuring AU-3—TUG-2—VC-11—T1
• Configuring Mediatype Controller
• Configuring Rate on SDH Ports
• Configuring AU-3 or AU-4 Mapping
• Configuring Mode VC-1x
• Configuring AU-3—TUG-2—VC-12—E1
• Configuring Mediatype Controller
• Configuring Rate on SDH Ports
• Configuring AU-3 or AU-4 Mapping
• Configuring Mode VC-1x
• Configuring AU-3—TUG-2—VC-11—T1
• Configuring Mediatype Controller
• Configuring Rate on SDH Ports
• Configuring AU-3 or AU-4 Mapping
• Configuring Mode VC-1x
• Configuring AU-3—TUG-2—VC-12—E1
ASR 900 Series)
SDH Multiplexing
75