Configuring Clocking For Acr And Dcr On Aps For Cesopsn; Configuring Dcr In Ct3-T1 Mode For Cesopsn - Cisco ASR 900 Series Configuration Manual

Configuring DCR in CT3-T1 mode for CESoPSN

18
2
Configuring DCR in CT3-T1 mode for CESoPSN
To configure the CEM group in the SONET controller:
configure terminal
controller sonet <bay>/<slot>/<port>
rate OC3
sts-1 <num>
mode ct3
t1 <t1_num> clock source recovered <clock-id>
t1 <t1_num> cem-group <cem-group-no> timeslots <1-24>
interface cem <bay>/<slot>/<port>
cem < cem-group-no>
rtp-present
To configure recovered clock for CESoPSN:
recovered-clock <bay> <slot>
clock recovered <clock-id> differential cem <port-no> <cem-group-no> priority <priority no>
Verifying DCR in CT3-T1 mode for CESoPSN
Use the show recovered-clock command to verify the DCR for CEM groups 31 and 32 configured in CT3
mode on T1 interface:
Router#show recovered clock
Recovered clock status for subslot 0/5
----------------------------------------
Clock
17
18

Configuring Clocking for ACR and DCR on APS for CESoPSN

Configuring Clocking for ACR on APS CT3-T1 in CESoPSN
For clocking, you need to configure Sonet controllers with prriority.
To configure clock source in CT3 mode of STS-1 for CESoPSN, use the following commands:
enable
configure terminal
controller mediatype 0/5/0
mode sonet
controller sonet 0/5/0
rate oc3
sts-1 1
mode ct3
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x
(Cisco ASR 900 Series)
60
OCx-T1 ADAPTIVE
Type Mode
Priority
OCx-T1 DIFFERENTIAL
2
OCx-T1 DIFFERENTIAL
2
34 ACQUIRED n/a
CEM Status Frequency Offset(ppb)
31 ACQUIRING n/a
32 ACQUIRED n/a
Configuring SONET
0/1/4 (Port/t3/t1)
Circuit-No
0/1/3 (Port/t3/t1)
0/1/4 (Port/t3/t1)