Configuring Au-4 — Tug-3 — Tug-2 — Vc-11 — T1 - Cisco ASR 900 Series Configuration Manual

Configuring SDH on 1-Port OC-192/STM-64 or 8-Port OC-3/12/48/STM-1/-4/-16 Module
tug-2 5 payload VC11
tug-2 6 payload VC11
tug-2 7 payload VC11
end
When you configure mode VC-1x, seven TUG-2 payloads are created. TUG-2 payloads can be of two
Note
types, VC-11 and VC-12. Default for TUG-2 payload mode is VC-11.
TUG-2 payload VC-11 can be configured as VC or T1 and the range is 1 to 4.
TUG-2 payload VC-12 can be configured as VC or E1 and the range is 1 to 3.
Configuring AU-4 — TUG-3 — TUG-2 — VC-11 — T1
To configure AU-4 — TUG-3 — TUG-2 — VC-11 — T1:
enable
configure terminal
controller sdh 0/5/0
rate stm4
au-4 1
mode tug-3
tug-3 1
mode vc1x
tug-2 1 payload vc11
t1 1 cem-group 10 unframed
vc 1 overhead v5 2
interface cem 0/5/0
cem 100
xconnect 2.2.2.2 10 encapsulation mpls
end
Note Overhead v5 has to be matched with the peer end.
Configuring AU-4 — TUG-3 — TUG-2 — VC-12
Use the following commands to configure AU-4 — TUG-3 — TUG-2 — VC-12:
enable
configure terminal
controller sdh 0/5/0
rate stm4
au-4 1
mode tug-3
tug-3 1
mode vc1x
tug-2 3 payload vc12
e1 1 cem-group 10 unframed
vc 1 overhead v5 2
end
Overhead v5 should match with the peer end.
Note
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x (Cisco
Configuring Modes under AU-4 Mapping
ASR 900 Series)
81