Configuring Cem Group For Au4-E1 On Sdh For Cesopsn - Cisco ASR 900 Series Configuration Manual

Configuring CEM Group for AU4-E1 on SDH for CESoPSN

Configuring CEM Group for AU4-E1 on SDH for CESoPSN
To configure MediaType controller and rate on SDH port, use the following commands:
enable
configure terminal
controller mediatype 0/5/0
mode sdh
controller sdh 0/5/0
rate stm1
end
To configure CEM group for AU4-E1 on SDH for CESoPSN, use the following commands:
enable
configure terminal
controller sdh 0/5/0
aug mapping au-4
au-4 1
mode tug-3
tug-3 1
mode vc1x
Tug-2 1 payload vc12
e1 1 cem-group 0 timeslots 1 - 7
vc 1 overhead v5 2
end
Verifying CEM Group for AU4-E1 on SDH for CESoPSN
This section includes show command to verify CEM Group for AU4-E1 on SDH for CESoPSN:
Router# show cem circuit interface cem 0/5/0
sdh0/5/0, ID: 0, Line: UP, Admin: UP, Ckt: ACTIVE
Path Mode : VC1X,Payload:VC12, AU4: 1, TUG-3: 1, E1: 1,CEM Mode: sdh-CESoP
Controller state: up, T1/E1 state: up
Idle Pattern: 0xFF, Idle CAS: 0x8
Dejitter: 6 (In use: 0)
Payload Size: 56
Framing: Framed (DS0 channels: 1-7)
CEM Defects Set
None
Signalling: No CAS
RTP: No RTP
Ingress Pkts:
Egress Pkts:
CEM Counter Details
Input Errors:
Pkts Missing:
Misorder Drops:
Error Sec:
Unavailable Sec: 0
Pkts Malformed:
Generated Lbits: 0
Generated Rbits: 868
Generated Mbits: 146392
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x
(Cisco ASR 900 Series)
106
Configuring SDH on 1-Port OC-192/STM-64 or 8-Port OC-3/12/48/STM-1/-4/-16 Module
54113124 Dropped:
54112259 Dropped:
0 Output Errors:
868 Pkts Reordered:
0 JitterBuf Underrun:
0 Severly Errored Sec: 0
Failure Counts:
0 JitterBuf Overrun:
Received Lbits:
Received Rbits:
Received Mbits:
0
0
0
0
869
28
0
0
1830
232588