Configuring Dcr In Mode T3 For Satop - Cisco ASR 900 Series Configuration Manual

Configuring DCR in Mode T3 for SAToP

rtp-present
!
Verifying Recovered Clock
Router# show recovered-clock
Recovered clock status for subslot 0/4
----------------------------------------
Clock
0
(Port/t3/t1)
Router# show running-config | section recovered-clock 0 4
recovered-clock 0 4
clock recovered 10 differential cem 1 0
Configuring DCR in Mode T3 for SAToP
enable
configure terminal
recovered-clock
clock recovered <clock-id> differential cem <port-no> <cem-group-no>
controller sonet <bay>/<slot>/<port>
rate OC3
sts-1 <number>
mode t3
cem-group <cem-group-number> unframed
t3 clock source recovered <clock-id>
interface cem <bay>/<slot>/<port>
cem <cem-group-nber>
rtp-present
end
Verifying DCR in Mode T3 for SAToP
Verifying DCR Configuration
Router# show running-config | section 0/4/6
controller SONET 0/4/6
rate OC3
no ais-shut
framing sonet
clock source internal
!
sts-1 1
clock source internal
mode t3
cem-group 0 unframed
clock source recovered 20
interface CEM0/4/6
no ip address
cem 0
rtp-present
!
Verifying Recovered Clock
Router# show recovered-clock
Recovered clock status for subslot 0/4
----------------------------------------
Clock
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x
(Cisco ASR 900 Series)
144
Type Mode CEM
OCx-ds1 Differential
<bay> <slot>
Type Mode CEM
Status Frequency Offset(ppb)
0 ACQUIRED n/a
Status Frequency Offset(ppb)
Clock Recovery System for SAToP
Circuit-No
0/1/1
Circuit-No