Verifying Acr In Mode Vt15 For Satop - Cisco ASR 900 Series Configuration Manual

Configuring ACR for OCn
To configure ACR in mode VT15 for Structure-Agnostic TDM over Packet (SAToP):
enable
configure terminal
controller sonet <bay>/<slot>/<port>
rate OC3
sts-1 <number>
mode vt-15
vtg 1 t1 cem 0 unframed
vtg 1 t1 1 clock source recovered 1
vtg <vtg_number> t1 <t1_number> cem-group < cem-group-no> unframed
vtg <vtg_number> t1 <t1_number> clock source recovered <clock-id>
exit
recovered-clock 0 <0-15> Subslot number
end

Verifying ACR in Mode VT15 for SAToP

Verifying ACR Configuration
Router# show running-config | section 0/4/0
controller MediaType 0/4/0
mode sonet
controller SONET 0/4/0
rate OC48
no ais-shut
framing sonet
clock source internal
!
sts-1 1
clock source internal
mode vt-15
vtg 1 t1 1 clock source Recovered 0
vtg 1 t1 1 framing unframed
vtg 1 t1 1 cem-group 0 unframed
interface CEM0/4/0
no ip address
cem 0
!
Verifying Recovered Clock
Router# show recovered-clock
Recovered clock status for subslot 0/3
----------------------------------------
Clock
0
(Port/path/vtg/t1)
Router# show running-config | section recovered-clock 0 4
recovered-clock 0 4
clock recovered 0 adaptive cem 0 0
Configuring ACR in mode T3 for SAToP
You must configure ACR in mode T3. Mode T3 is STS-1 or AU-4/TUG3 carrying an unchannelized (clear
channel) T3.
enable
configure terminal
recovered-clock
clock recovered <clock-id> adaptive cem <port-no> <cem-group-no>
controller sonet <bay>/<slot>/<port>
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x
(Cisco ASR 900 Series)
138
Type Mode CEM
OCx-ds1 ADAPTIVE 0
<bay> <slot>
Status Frequency Offset(ppb)
ACQUIRED n/a
Clock Recovery System for SAToP
Circuit-No
0/1/1/1