Verification Of Sncp Configuration - Cisco ASR 900 Series Configuration Manual

Configuring SNCP on 1-Port OC192/STM-64 or 8-Port OC3/12/48/STM-1/-4/-16 Module
au-4 1-16 mode vc4-16c
protection group 1 protect
end
CEM Group Configuration
enable
configure terminal
controller sdh 0/4/1
au-4 1-16 mode vc4-16c
cem-group 1 cep
end
Local Connect Configuration
enable
configure terminal
connect lc cem 0/4/1 1 cem-pg 1 16001
end

Verification of SNCP Configuration

Use show protection-group command to verify SNCP configuration:
#show protection-group
PGN
-------------------------------------------------------------------------------
1
-------------------------------------------------------------------------------
Status legend:D=Deleted FO=Force SF=SignalFailure SD=SignalDegrade
(W)=working, (P)=protect
Type Working I/f
VC4-16C SDH0/3/6.1-48
FL=Fail M=Manual L=Lockout C=Clear A=Auto
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x (Cisco
Verification of SNCP Configuration
Protect I/f
SDH0/12/6.1-48
Active Status
P A
ASR 900 Series)
127