Configuring Path Threshold - Cisco ASR 900 Series Configuration Manual

Configuring SONET
To configure the J1 flag, use the following commands:
enable
configure terminal
controller sonet 0/5/0
sts-1 1
overhead j1 expected length
end

Configuring Path Threshold

To configure path threshold, use the following commands:
enable
configure terminal
controller sonet 0/5/0
sts-1 1
threshold b3-tca 3
end
Verification of SONET Configuration
The following sample output shows the verification of SONET configuration:
Router#show controllers sonet 0/3/3
SONET 0/3/3 is up.
status.
Hardware is asr900
Port configured rate: OC3
on it.
Applique type is Channelized Sonet / SDH
Clock Source is Line
Medium info:
Type: Sonet, Line Coding: NRZ,
SECTION:
LOS = 0
counter (from last clear counters)
SONET/SDH Section Tables
INTERVAL
05:50-05:58
port
LINE:
AIS = 0
alarm counter (from last clear counters)
Active Defects: None
Detected Alarms: None
Asserted/Active Alarms: None
alarms on the port.
Alarm reporting enabled for: SLOS SLOF SF B2-TCA
BER thresholds:
TCA thresholds:
Rx: S1S0 = 00
K1 = 00,
J0 = 00
RX S1 = 00
Tx: S1S0 = 00
K1 = 00,
J0 = 00
High Order Path:
PATH 1:
Clock Source is internal
AIS = 0
LOF = 0
CV ES SES
0 0 0
RDI = 0
SF = 10e-3 SD = 10e-6
B2 = 10e-6
K2 = 00
K2 = 00
RDI = 0
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x (Cisco
======> this is the controller/port
=======> this is the rate the port is configured
===> the clocking config
=======> the section level alarm
SEFS
0
REI = 0 BIP(B2) = 0
===> k1k2 values
====> path level clock
REI = 0 BIP(B3) = 0
Managing and Monitoring SONET Line
===> PMON for the
=======> the line level
=========> present active
====> ber thresholds
======>
ASR 900 Series)
path
45