Configuring Au-3 — Tug-2 — Vc-11 — T1 - Cisco ASR 900 Series Configuration Manual

Configuring SDH on 1-Port OC-192/STM-64 or 8-Port OC-3/12/48/STM-1/-4/-16 Module
rate stm4
au-3 1
mode vc1x
tug-2 1 payload vc12
vc 1 cem-group 10 cep
end
Configuring AU-3 — TUG-2 — VC-11 — T1
To configure AU-3 — TUG-2 — VC-11 — T1:
configure terminal
controller MediaType 0/5/0
mode sdh
controller sdh 0/5/0
rate stm4
au-3 1
mode vc1x
tug-2 1 payload vc11
t1 1 cem-group 10 unframed
vc 1 overhead v5 2
interface cem 0/5/0
cem 100
xconnect 2.2.2.2 10 encapsulation mpls
end
Configuring AU-3 — TUG-2 — VC-12 — E1
To configure AU-3 — TUG-2 — VC-12 — E1:
configure terminal
controller MediaType 0/5/0
mode sdh
controller sdh 0/5/0
rate stm4
au-3 1
mode vc1x
tug-2 3 payload vc12
e1 1 cem-group 10 unframed
vc 1 overhead v5 2
end
Verifying Mode VC-1x Configuration
Use show running-configuration command to verify mode VC-1x configuration.
#show running-configuration
controller MediaType 0/3/4
mode sdh
controller SDH 0/3/4
rate STM4
no ais-shut
alarm-report all
threshold sf-ber 3
clock source internal
overhead s1s0 0
aug mapping au-3
au-3 1
clock source internal
mode VC1x
tug-2 1 payload VC11
t1 1 cem-group 1 unframed
tug-2 2 payload VC11
vc 1 cem-group 2 cep
tug-2 3 payload VC12
e1 1 cem-group 3 unframed
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x (Cisco
Configuring Modes under AU-3 Mapping
ASR 900 Series)
85