Cisco ASR 900 Series Configuration Manual page 61

Configuring SONET
The following table shows each field and its description.
Table 3: Field Description
Field
SONET 0/3/3 is up
Port configured rate: OC3
SECTION: LOS = 0 LOF = 0 BIP = 0
SONET Section Tables:
INTERVAL CV ES SES SEFS
05:50-05:58 0 0 0 0
LINE:
AIS = 0 RDI = 0 REI = 0 BIP(B2) = 0
Asserted/Active Alarms: None
BER thresholds: SF = 10e-3 SD = 10e-6
K1 = 00, K2 = 00
PATH 1:
Clock Source is internal
AIS = 0 RDI = 0 REI = 0 BIP(B3) = 0 LOP = 0 PSE
= 0 NSE = 0 NEWPTR = 0 LOM = 0 PLM = 0 UNEQ
= 0
Active Defects: None
Detected Alarms: None
Asserted/Active Alarms: None
Alarm reporting enabled for: PLOP LOM B3-TCA
TCA threshold: B3 = 10e-6
Rx: C2 = 00 =====> rx and tx C2 byte..
Tx: C2 = 02
PATH TRACE BUFFER : UNSTABLE
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
................
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x (Cisco
Managing and Monitoring SONET Line
Description
Shows that the SONET controller is operating. The
controller's state can be up, down, or administratively
down.
Shows the rate configured on the port.
Shows the section level alarm counters.
Shows the PMON for the port.
Shows the line level alarm counters.
Shows the active alarms on the port.
Shows BER thresholds.
Shows the K1 and K2 values.
Shows the path level clock.
Shows the path layer alarm counters.
Shows the alarms on the path.
shows the Rx and Tx C2 bytes.
Shows the path trace.
ASR 900 Series)
47