Configuring Bert In Sonet For Cesopsn - Cisco ASR 900 Series Configuration Manual

Configuring SONET
High transmit power alarm threshold
High transmit power warning threshold
Low transmit power warning threshold
Low transmit power alarm threshold
High receive power alarm threshold
Low receive power alarm threshold
High receive power warning threshold
Low receive power warning threshold
External Calibration: bias current slope
External Calibration: bias current offset = 0
show hw-module subslot <slot/bay> transceiver <port> idprom brief:
sh hw-module subslot 0/7 transceiver 6 idprom brief
IDPROM for transceiver SPA-1T8S-10CS_7/6:
Description
Transceiver Type:
Product Identifier (PID)
Vendor Revision
Serial Number (SN)
Vendor Name
Vendor OUI (IEEE company ID)
CLEI code
Cisco part number
Device State
Date code (yy/mm/dd)
Connector type
Encoding
Nominal bitrate
Minimum bit rate as % of nominal bit rate = not specified
Maximum bit rate as % of nominal bit rate = not specified

Configuring BERT in Sonet for CESoPSN

Bit-Error Rate Testing (BERT) is used for analyzing quality and for problem resolution of digital transmission
equipment. BERT tests the quality of an interface by directly comparing a pseudorandom or repetitive test
pattern with an identical locally-generated test pattern.
The supported BERT patterns are 2^11, 2^15, 2^20-O153, and 2^20-QRSS.
BERT is supported in the following two directions:
• Line—Supports BERT in TDM direction.
• System—Supports BERT in PSN direction.
BERT is supported in following controllers:
• T1—NxDS0, DS1
• T3—NxDS0, DS1 (channelised), clear channel DS3.
• OCx—NxDS0, DS1 (channelised), DS3 (channelised), clear channel DS3, STS1, STS-nc, VT-1.5, VT1.5
The following table shows the supported SONET level of BERT patterns.
T1
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x (Cisco
Configuring BERT in Sonet for CESoPSN
= 4.0 dBm
= 2.0 dBm
= -7.0 dBm
= -9.0 dBm
= 1.0 dBm
= -26.0 dBm
= -1.0 dBm
= -24.9 dBm
= 1.000
= SFP or SFP+ optics (type 3)
= ONS SE Z1 (406)
= ONS-SE-Z1
= A
= FNS19251NQ0
= CISCO-FINISAR
= 00.90.65 (36965)
= WMOTCZPAAA
= 10-1971-04
= Enabled.
= 15/06/19
= LC.
= 8B10B
NRZ
Manchester
= OC48/STM16 (2500 Mbits/s)
ASR 900 Series)
53