Cisco ASR 900 Series Configuration Manual page 56

Managing and Monitoring SONET Line
Controller state: up, T1/E1 state: up
Idle Pattern: 0xFF, Idle CAS: 0x8
Dejitter: 6 (In use: 0)
Payload Size: 192
Framing: Unframed
CEM Defects Set
None
Signalling: No CAS
RTP: Configured, RTP-HDR Compression: Disabled
Ingress Pkts:
Egress Pkts:
CEM Counter Details
Input Errors:
Pkts Missing:
Misorder Drops:
Error Sec:
Unavailable Sec: 0
Pkts Malformed:
Generated Lbits: 0
Generated Rbits: 0
The following example shows the MPLS L2 transport vc details for the specified vc. In this case it is the vc
with vc-id = 1001:
Router# sh mpls l2 vc 1 det
Local interface: CE1 up, line protocol up, SATOP T1 1 up
Destination address: 2.2.2.2, VC ID: 1, VC status: up
Output interface: Te0/8/0, imposed label stack {100}
Preferred path: not configured
Default path: active
Next hop: 31.1.1.2
Create time: 02:48:15, last status change time: 02:47:26
Last label FSM state change time: 02:47:26
Signaling protocol: LDP, peer 2.2.2.2:0 up
Targeted Hello: 1.1.1.1(LDP Id) -> 2.2.2.2, LDP is UP
Graceful restart: not configured and not enabled
Non stop routing: configured and enabled
Status TLV support (local/remote)
LDP route watch
Label/status state machine
Last local dataplane
Last BFD dataplane
Last BFD peer monitor
Last local AC
Last local AC
Last local PW i/f circ status rcvd: No fault
Last local LDP TLV
Last remote LDP TLV
Last remote LDP ADJ
MPLS VC labels: local 16, remote 100
Group ID: local 38, remote 36
MTU: local 0, remote 0
Remote interface description:
Sequencing: receive disabled, send disabled
Control Word: On (configured: autosense)
SSO Descriptor: 2.2.2.2/1, local label: 16
Dataplane:
SSM segment/switch IDs: 274581/4096 (used), PWID: 1
VC statistics:
transit packet totals: receive 0, send 0
transit byte totals:
transit packet drops:
The following example shows the currently configured APS groups on the router:
Router# show aps
SONET 0/5/2 APS Group 25: protect channel 0 (Inactive) (HA)
Working channel 1 at 1.1.1.1 (Enabled) (HA)
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x
(Cisco ASR 900 Series)
42
8186065 Dropped:
8186065 Dropped:
0 Output Errors:
0 Pkts Reordered:
0 JitterBuf Underrun:
0 Severly Errored Sec: 0
Failure Counts:
0 JitterBuf Overrun:
Received Lbits:
Received Rbits:
: enabled/supported
: enabled
: established, LruRru
status rcvd: No fault
status rcvd: Not sent
status rcvd: No fault
circuit status rcvd: No fault
circuit status sent: No fault
status sent: No status
status rcvd: No fault
status rcvd: No fault
receive 0, send 0
receive 0, seq error 0, send 0
Configuring SONET
0
0
0
0
0
0
0
0
0