Configuring Clocking Acr For Msp Au3-T1 In Cesopsn - Cisco ASR 900 Series Configuration Manual

Configuring MSP on 1-Port OC192/STM-64 or 8-Port OC3/12/48/STM-1/-4/-16 Module
Dejitter: 6 (In use: 0)
Payload Size: 56
Framing: Framed (DS0 channels: 1-7)
CEM Defects Set
None
Signalling: No CAS
RTP: No RTP
Ingress Pkts:
Egress Pkts:
CEM Counter Details
Input Errors:
Pkts Missing:
Misorder Drops:
Error Sec:
Unavailable Sec: 0
Pkts Malformed:
Generated Lbits: 0
Generated Rbits: 868
Generated Mbits: 146392

Configuring Clocking ACR for MSP AU3-T1 in CESoPSN

To configure clock source on MSP for the working controller, use the following commands:
enable
configure terminal
controller sdh 0/3/6
au-3 1
tug-2 1 payload vc11
t1 1 clock source recovered 1
end
To configure the recovered clock, use the following commands:
enable
configure terminal
recovered-clock acr 200
clock recovered 1 adaptive cem 1 priority 1
end
To configure clock source on MSP for the protect controller, use the following commands:
enable
configure terminal
controller sdh 0/4/6
au-3 1
tug-2 1 payload vc11
t1 1 clock source recovered 1
end
To configure the recovered clock, use the following commands:
enable
configure terminal
recovered-clock acr 200
clock recovered 1 adaptive cem 2 priority 2
end
54113124
54112259
0
0
0
0
0
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x (Cisco
Configuring Clocking ACR for MSP AU3-T1 in CESoPSN
Dropped: 0
Dropped: 0
Output Errors: 0
Pkts Reordered: 0
JitterBuf Underrun: 869
Severly Errored Sec: 0
Failure Counts: 28
JitterBuf Overrun: 0
Received Lbits: 0
Received Rbits: 1830
Received Mbits: 232588
ASR 900 Series)
121