Shutting Down A Cem Channel - Cisco ASR 900 Series Configuration Manual

Configuring DS1 CT3 SAToP Mode

Shutting Down a CEM Channel

To shut down a CEM channel, use the shutdown command in CEM configuration mode. The shutdown
command is supported only under CEM mode and not under the CEM class.
Configuring DS1 CT3 SAToP Mode
To configure DS1 CT3 SAToP mode, use the following commands:
enable
configure terminal
controller MediaType 0/4/11
mode sonet
controller sonet 0/5/0
rate oc12
sts-1 1
mode ct3
t1 1 cem-group 100 unframed
t1 1 framing unframed
interface cem 0/5/0
cem 100
xconnect 2.2.2.2 10 encapsulation mpls
end
Configuring VT DS1 SAToP Mode
To configure VT DS1 SAToP mode, use the following commands:
enable
configure terminal
controller MediaType 0/5/0
mode sonet
controller sonet 0/5/0
rate oc12
sts-1 1
mode vt-15
vtg 1 t1 1 framing unframed
vtg 1 t1 1 cem-group 0 unframed
end
Configuring STS-Nc CEP
To configure STS-Nc CEP, use the following commands:
enable
configure terminal
controller MediaType 0/5/0
mode sonet
controller sonet 0/5/0
rate oc12
sts-1 1 - 3 mode sts-3c
cem-group 100 cep
interface cem 0/5/0
cem 100
xconnect 2.2.2.2 10 encapsulation mpls
end
1-Port OC-192 or 8-Port Low Rate CEM Interface Module Configuration Guide, Cisco IOS XE Everest 16.7.x
(Cisco ASR 900 Series)
4
Configuring CEM