Verification Of Lsm Mldp Based Mvpn Configuration - Cisco CRS Series Configuration Manual

Implementing Multicast Routing on Cisco IOS XR Software
Command or Action
Step 22
address-family [ipv4 | ipv6 ]
Example:
RP/0/RP0/CPU0:router(config-pim-vrf1)#
address-family ipv4
Step 23 rpf topology route-policy route_policy_name
Example:
RP/0/RP0/CPU0:router(config-pim-vrf1-af)# rpf
topology route-policy FOO
Step 24 root
Example:
RP/0/RP0/CPU0:router(config-pim-vrf1-af)# root
Step 25 route-policy route_policy_name
Example:
RP/0/RP0/CPU0:router(config)# route-policy
FOO
Step 26 set core-tree tree_type
Example:
RP/0/RP0/CPU0:router(config-rpl)# set
core-tree mldp-rosen
Step 27 commit

Verification of LSM mLDP based MVPN Configuration

Use these commands to verify the LSM mLDP based MVPN intranet configuration:
• To check the MLDP neighbors, use the show mpls mldp neighbors command:
Router# show mpls mldp neighbors
mLDP neighbor database
MLDP peer ID : 1.0.0.1:0, uptime 15:36:30 Up,
Capabilities : GR, Typed Wildcard FEC, P2MP, MP2MP, MBB
Target Adj : No
Upstream count : 0
Branch count : 0
LDP GR : Enabled
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
Purpose
Enters the address-family submode.
Assigns a given routing policy to an RPF topology table.
Takes the user to the global configuration mode.
Configures the route policy for a profile. For more
information about configuring route policy, see Cisco IOS
XR Routing Configuration Guide.
Specifies the MDT type for the route policy.
Configuring Multicast VPN
113