Configuring A Configuration Group - Cisco ASR 9000 Series User Configuration Manual

Configuring Flexible Command Line Interface Configuration Groups
• Commands that require a node identifier for the location keyword are not supported. For example, this
• Overlapping regular expressions within a configuration group for the same configuration are not supported.
• Up to eight configuration groups are permitted on one apply-group command.

Configuring a Configuration Group

A configuration group includes a series of configuration statements that can be used in multiple hierarchical
levels in the router configuration tree. By using regular expressions in a configuration group, you can create
generic commands that can be applied in multiple instances.
Use this task to create and use a configuration group.
Flexible CLI configurations are not available through the XML interface.
Note
◦The choice operator "|" to express multiple match expressions within a regular expression is not
supported. For example, these expressions are not supported:
—To match on either Gigabit Ethernet main interfaces or Gigabit Ethernet
Gig.*|Gig.*\..*
sub-interfaces.
Gig.*0/0/0/[1-5]|Gig.*0/0/0/[10-20]
Gig.*0/0/0/[10-20].
—To match on either TenGigE.* or POS.* .
'TenGigE.*|POS.*
configuration is not supported:
lpts pifib hardware police location 0/0/CPU0
For example:
group G-INTERFACE
interface 'gig.*a.*'
mtu 1500
!
interface 'gig.*e.* '
mtu 2000
!
end-group
interface gigabitethernet0/4/1/0
apply-group G-INTERFACE
This configuration is not permitted because it cannot be determined whether the
configuration inherits
gigabitethernet0/4/1/0
configuration group match gigabitethernet0/4/1/0.
Cisco ASR 9000 Series Aggregation Services Router System Management Configuration Guide, Release 5.1.x
Configuring a Configuration Group
—To match on either Gig.*0/0/0/[1-5] or
or . Both expressions in the
mtu 1500 mtu 2000
interface
131