C–Fx Routing - Korg KROSS Parameter Manual

Combination mode
9: C–FX ROUTING
You can also specify the bus routing for the program used by each
of the timbres, 1–16. For instance, you can:
• Send the output of a timbre to an insert effect
• Route a sound to an insert effect
• Create detailed settings for insert effects
For more details on the Insert Effects, please see the "Effect
Guide" on page 207.
9–1: BUS
Specifies the bus where the program oscillator(s) used by timbres
1–16 will be sent.
Routing Map
This shows the status of the insert effects.
This area shows the insert effect routing (Bus Select), the name of
the assigned effect, the on/off status, chaining, and the output bus
that follows the insert effect. The type of insert effect, the on/off
status, and the chain settings can all be edited in the C–
ROUTING> IFX page.
Timbre 01...16 (Timbre Number)
To select a timbre (active timbre), place the cursor at one of the
following parameters, and use the cursor buttons   to switch
timbres. The indication for the active timbre is highlighted. (see
page 71)
Bus (Bus Select)
This specifies the output bus for the timbre's program oscillator.
L/R: Output to the L/R bus.
IFX1...5: Output to the IFX1–5 buses.
Off: The timbre will not be output from the L/R bus, or IFX1–5
buses. Choose the Off setting if you want the program oscillator
output of the timbre to be connected to a master effect. Use SEND
page Send1 (to MFX1) and Send2 (to MFX2) to specify the send
levels.
Tip: You can create a wide variety of routings by using each
timbre's Bus Select and the Chain to and Chain settings (C–
ROUTING> IFX) that follow the insert effect.
Example: Inserting a single IFX into multiple timbre
90
[DKit, L/R, IFX1...5, Off]
Example: Inserting a separate IFX into each timbre, and then in-
serting an IFX at the final stage
Example: Sharing a portion of a timbre's IFX chain with another
timbre
DKit: This can be selected only if the timbre's program is a drum
program (Oscillator Mode Drums).
The Bus Select, FX Control Bus, Send1, and Send2
(DRUMKIT> VOICE) settings for each key of the selected Dkit
will be used. Check this setting if you want to apply an individual
insert effect to each drum instrument.
Tip: In most preloaded drumkits, the drum instruments have the
same Bus Select settings according to their type, as follows.
Snares → IFX1
Kicks → IFX2
Cymbals → IFX3
Tam, percussions, and others → IFX4
If you want to edit these routings, use the Dkit IFX Patch
function. For more information, please see the "DKit IFX Patch"
section on page 96.