Vel Zone (Velocity Zone) - Korg KROSS Parameter Manual

Combination mode
4–2: VEL ZONE (Velocity Zone)
Top Velocity
Top Slope
Bottom Slope
1
Bottom Velocity
Sets the Top/Bottom Velocity parameters to specify the range of
velocities that will sound for each timbre 1–16, and set the Top/
Bottom Slope parameters to specify the range where the volume
will change.
Velocity switch: If you set different velocity zones for multiple
timbres so that they do not sound together, you can play separate
sounds by varying playing dynamics.
Layer: If you set two or more timbres to velocity zones that
overlap, the sounds will be heard together.
Velocity Cross-fade: If the slope ranges (gray line) overlap,
different sounds will be sounded together, and your playing
dynamics will determine the proportion of each sound.
It is not possible to set the bottom velocity greater than the
top velocity for the same timbre, nor can the top slope and the
bottom slope overlap.
Zone Map
This area indicates velocity ranges where each timbre will sound.
A line indicates the range of notes that will sound, and the slope
within that range is shaded.
Timbre 01...16 (Timbre Number)
To select a timbre (active timbre), place the cursor at one of the
following parameters, and use the cursor buttons   to switch
timbres.(see page 71)
Top Velocity
Specifies the maximum velocity value that will sound each timbre.
Top Slope
Specifies the number of velocity steps where the original volume
will be reached, starting from the Top Velocity.
0: The volume will be at the original value from the top velocity.
120: The volume will decrease as the velocity approaches the top
velocity.
Bottom Slope
Specifies the number of velocity steps where the original volume
will be reached, starting from the Bottom Velocity.
0: The volume will be at the original value from the bottom
velocity.
120: The volume will decrease as the velocity approaches the
bottom velocity.
Bottom Velocity
Specifies the minimum velocity value that will sound each timbre.
80
16
Timbre
[001...127]
[000...120]
[000...120]
[001...127]
How volume will change according to keyboard location
Volume
Bottom Slope
Bottom Velocity
Note: You can also set the note values and velocity values by the
keyboard. (see page 13 of the Operation Guide )
Velocity
Top Slope
Top Velocity