Delay - Korg KROSS Parameter Manual

4–3: DELAY
This specifies the time (delay) from when the timbres 1–16 receive
a note-on until the sound begins.
Timbre 01...16 (Timbre Number)
To select a timbre (active timbre), place the cursor at one of the
following parameters, and use the cursor buttons   to switch
timbres.(see page 71)
Delay Time [ms]
Specifies the time (delay time) from note-on until the timbre
begins to produce sound, in units of ms (1/1000th of a second).
This setting is available if MIDI/Tempo Sync. is set to Off.
KeyOff: The note will begin sounding at note-off. In this case, the
sound will not die away if the sustain level of the program's amp
EG is other than 0. This setting is used when creating harpsichord
sounds.
Normally you will set this to 0000.
MIDI/Tempo Sync.
The time (delay time) from note-on until the timbre produces
sound will be specified in note length units relative to the
(Tempo).
On (checked): Specify the delay time in terms of a Base Note and
Times relative to the Tempo. For example if Base Note = , Times
= 01, and Tempo = 60 BPM, the delay time will be equivalent to
1000 ms.
Off (unchecked): The delay time will be set by the Delay Time
setting.
Base Note
Times
It specifies the time (delay time) from note-on until the timbre
begins to produce sound, in terms of a note value relative to the
(Tempo) (COMBI> MAIN).
Use Base Note to specify the desired note value, and use Times to
extend that note value by the specified multiple.
For example if you set Base Note to a quarter note ( ) and Times
to 02, that timbre will sound with a delay of a half note ( ). Even
if you change (Tempo) , the delay time will always be a half note
( ). If you use these parameters to specify a delay of a half note
( ). In this case, a Tempo of 60.00 BPM will produce a 2000 ms
delay, and a Tempo of 120.00 BPM will produce a 1000 ms delay.
Timbre Info.
Shows the settings of timbres 1–16 for the parameter that you're
editing.
Soloed timbres are indicated by (S).
[0000...5000ms, KeyOff]
[Off, On]
[ , , , , , , , , , ]
[x1...x32]
4: C–ZONE/DELAY 4–3: DELAY
4–1...3: FUNCTION
V
• 0: Write Combination, Write/Initialize Combination
94
• 1: Solo Setting see page 63
• 2: Compare see page 64
• 3: Auto Song Setup see page 64
• 4: Add to Favorite see page 94
• 5: Copy from Program see page 95
For more information, please see the "Combination: FUNCTION"
section on page 94.
see page
81