Korg KROSS Parameter Manual page 72

Program mode
Compare
Use this function when you want to compare the sound of the
program you're editing with the sound prior to editing (i.e., the
saved sound).
While editing a program, you can turn on the Compare function
(select the check mark) to recall the settings that were last written
to that program number. When you turn off the Compare function
(clear the check mark), you will return to the settings that you had
been editing.
1. While editing, select this function and turn it on (select the
check mark).
The sound that had been saved before you began editing will be
recalled.
2. When you turn off this function (clear the check mark), you
will return to the sound that you had been editing.
Note: If you edit the settings that were recalled by turning
Compare on (i.e., the saved settings), the check mark will be
cleared, and your previously edited settings will be lost. Even if
you turn Compare on again (select the check mark), the previous
settings will not return.
The Compare function is not available for editing that uses
the Tone Adjust parameters.
Auto Song Setup
This function automatically copies the settings of the program or
combination to a song, and enables the record-standby condition
(see "Auto Song Setup" on page 101).
Tips: You can also access and execute this function by pressing the
REC () button.
Add to Favorite
This function adds the program that you've selected in Program
mode (or the combination that you've selected in Combination
mode) to Favorites.
1. In Program mode or Combination mode, select a sound.
(see page 2, 70)
2. Choose this function to enter registration mode.
Tip: You can also enter registration mode by holding down the
EXIT button and pressing the FAVORITES button.
3. Use the BANK SELECT button to select a bank.
4. Press one of the 1–16 pads to register the sound to that but-
ton.
If you decide not to register the sound, press the EXIT button.
64
Hold Balance
1. Choose this function to turn it on (select the check mark).
2. When you adjust any volume setting, the other volume set-
tings will change to maintain the balance. This is conve-
nient when you want to adjust the overall volume.
Copy Oscillator
Copy Oscillator is available on all of the tabs under the P–
BASIC, P–OSC, P–PITCH, P–PITCH EG, P–FILTER, P–FILTER
EG, P–AMP, P–AMP EG, and P–AMS MIXER pages.
This function is used to copy the settings from one oscillator to
another.
1. Use From to select the copy-source program.
2. Select the oscillator that you want to copy.
3. In To, specify the copy destination oscillator.
Swap Oscillator
Swap Oscillator is available on all of the tabs under the P–
BASIC, P–OSC, P–PITCH, P–PITCH EG, P–FILTER, P–FILTER
EG, P–AMP, P–AMP EG, and P–AMS MIXER pages.
This function exchanges the settings of oscillators 1 and 2.
Note: This can be selected only if Oscillator Mode (P–BASIC>
VOICE) is Double.
Sync Both EGs
Sync Both EGs is available on the P–FILTER EG> ENVELOPE
and P–AMP EG> ENVELOPE pages.
This option allows you to edit the EGs of Oscillator 1 and
Oscillator 2 together. When it is checked, editing the Filter EG of
either Oscillator 1 or 2 will change both Filter EGs simultaneously.
Similarly, editing the Amp EG of either Oscillator will change
both Amp EGs.
This option is available when the Oscillator Mode is set to
Double.
1. Choose this function to turn it on (select the check mark).
The display will indicate "SYNC BOTH EG's" and the two EGs
will be synchronized.