Mod (Amp Modulation) - Korg KROSS Parameter Manual

8–2: MOD (Amp Modulation)
This page contains the settings for Oscillators 1 and 2's Amp level
modulation. Among other things, you can:
• Assign AMS modulation for the Amp level.
• Control the effect of the LFOs on the Amp level.
You can modulate the Amp level by both velocity and an AMS
source.
This modulation scales the basic Amp level and Amp EG level
parameters. The resulting volume is determined by multiplying the
volume changes of the amp EG by other values such as AMS. If
these original levels are low, the maximum volume available with
modulation will also be reduced.
OSC (Oscillator Select)
Select the oscillator (1 or 2) that you want to edit.
Note: Oscillator 2 can be selected if Oscillator Mode is set to
Double.
Velocity to EG
Velocity Intensity
With positive (+) values, the volume will increase as you play
harder.
With negative (–) values, the volume will decrease as you play
harder.
Velocity modulation of the Amp level, with Amp EG
Volume
Time
Low velocity
Modulation
AMS
This selects any AMS modulation source to control the Amp1
level. For a list of AMS sources, please see "AMS (Alternate
Modulation Source) List" on page 292.
AMS Intensity
This controls the depth and direction of the modulation.
For example, if AMS is set to M.Wheel:#01, positive (+) values
of this parameter will make the volume increase when you move
the modulation wheel away from yourself.
Note that if the other modulation settings have already raised the
volume to its maximum level (double the Amp Level and Amp
EG level settings), the volume cannot be increased any further.
LFO1
Intensity (LFO1)
This controls the depth and direction of LFO1's effect on the
oscillator's volume.
Negative (–) values will invert the LFO waveform.
AMS Intensity
[1, 2]
[–99...+99]
Time
High velocity
[List of AMS Sources]
[–99...+99]
[–99...+99]
8: P–Amp 8–2: MOD (Amp Modulation)
AMS (LFO1)
This selects an AMS modulation source to scale the amount of the
LFO1 that's applied to the Amp level.
For a list of AMS sources, please see "AMS (Alternate
Modulation Source) List" on page 292.
AMS Intensity
This controls the depth and direction of the LFO1 AMS
modulation for the Amp level.
LFO2
The parameters for LFO2 are identical to those for LFO1. For
more information, please see the descriptions under LFO1, above.
[List of AMS Sources]
[–99...+99]
33