C–Step Seq (Step Sequencer) - Korg KROSS Parameter Manual

Combination mode
8: C–STEP SEQ (Step Sequencer)
Here you can adjust settings for the step sequencer used by the
combination.
Note: To use the step sequencer, turn STEP SEQ On/Off "on"
(COMBI> PROG page).
MIDI transmission/reception for the step sequencer
Step sequencer functions in Combination mode are transmitted
and received using the MIDI channel of timbre 16.
The on/off state of the RUN button cannot be saved.
8–1: BASIC
Program
Here you can select the drum program that will be used by the step
sequencer.
This parameter is linked with the program select (COMBI> PROG
page) of timbre 16 when STEP SEQ is on.
(Tempo)
Resolution
Lgth (Length)
Step/Bt (Steps per Beat for Swing)
These settings are the same as for a program.
See "15–1: BASIC" on page 55
88
[000...(050)]
[40.00... 300.00, EXT]
[ , , , , , , , ]
[01...64]
[x1, x2, x4]
8–2: EDIT
Indicates the tone for which you can use the
front panel 1–16 pads to turn steps on/off.
When you turn RUN on, the indication will move
to the left, showing the currently-playing step.
STEP SEQ - SETUP button
STEP */*
ZONE
STATUS
TONE 01 (Kick/Note No.)
TONE 02 (Snr 1/Note No.)
TONE 03 (Snr 2/Note No.)
TONE 04 (H.H X/Note No.)
TONE 05 (H.H O/Note No.)
TONE 06 (Crash/Note No.)
TONE 07 (Ride/Note No.)
TONE 08 (Tom L/Note No.)
TONE 09 (Tom H/Note No.)
TONE 10 (Perc 1/Note No.)
TONE 11 (Perc 2/Note No.)
TONE 12 (SFX/Note No.)
ACCENT
These settings are the same as for a program.
See "15–2: EDIT" on page 56
[1...64/01...64]
[A, B, C, D]
[STOP, RUN]
[Step Off, On]
[Step Off, On]
[Step Off, On]
[Step Off, On]
[Step Off, On]
[Step Off, On]
[Step Off, On]
[Step Off, On]
[Step Off, On]
[Step Off, On]
[Step Off, On]
[Step Off, On]
[Off, On]