Korg KROSS Parameter Manual page 73

2. If you no longer want the EGs to be synchronized, select
Sync Both EGs once again.
The indication will disappear from the display.
Swap LFO 1&2
Swap LFO 1 & 2 is available on all of the P–OSC LFO pages.
This function copies the settings of LFO1 to LFO2, and vice-versa.
Note: If LFO2 is being used to modulate LFO1, this function will
erase that modulation routing.
Copy Arpeggiator
Copy Arpeggiator is available on the PROG> ARP, P–ARP page.
This function can be used to copy arpeggio settings from another
location to the current program.
1. Use From to select the copy-source.
2. If you are copying from Combination, or Song, specify
whether you wish to copy from A or B.
Copy Drum Track
Copy Drum Track is available on the P–DRUM TRACK page.
This function copies settings from the specified program,
combination/timbre, or song.
1. Use the From field to select the mode and number of the
desired copy-source.
2. If you use this function in Program mode, and select Pro-
gram in From, the additional field Program Settings too
will appear.
On (checked): All parameter settings in the P-DRUM TRACK>
PATTERN and PROG pages will be copied.
Off (unchecked): The parameter settings of the P-DRUM
TRACK> PATTERN page will be copied.
If you perform this function in Combination or Sequencer mode,
the parameter settings of the P-DRUM TRACK> PROG page will
be copied. However, the MIDI Channel setting will not be copied.
Program: Function Swap LFO 1&2
Assign inst to Tone
Here's how to assign an instrument to each tone of the step
sequencer..
Inst Variation Category
1. Choose this function.
Tip: You can also access this by holding down the SETUP button
and pressing one of the 1–12 buttons of the desired tone to make
the button light up, and then pressing the lit button again.
2. Use the "T" field to select the tone.
Tip: You can also switch tones by holding down the SETUP button
and pressing one of the 1–12 buttons where the desired tone is
assigned.
3. In the Inst Variation Category field, choose All or a cate-
gory.
If All is selected, you'll be able to choose drum sounds from all
instruments. If a category is selected, you'll be able to choose from
instruments of that category.
If the Inst Variation Category is set to a category, switching
programs may also cause the Inst Variation note number to be
switched. This is because an instrument of the same category
does not exist at the same note number as the program that
you changed, and therefore a nearby instrument of the same
category has been assigned automatically.
4. Select an instrument.
You can press the AUDITION button to hear the sound you
selected.
Tip: You can also play the keyboard to hear the candidate
instrument. If Inst Variation Category is set to All, all keys will
produce sound. If a category is selected, sound will be produced
only by the keys where a corresponding instrument has been
assigned.
You can also select by holding down the SETUP button and
playing a key.
5. When you've finished adjusting settings, press the OK but-
ton.
Edits Step Parameters
Here you can specify velocity and accent on/off for each step.
Copy Step Seq
This function copies the step sequencer settings from the program,
combination, or song that you specify.
1. Choose this function.
2. Use the From field to select the copy-source mode and
sound.
3. If you use this function from Program mode, and choose
Program as the From setting, the Program Setting too
option is displayed.
65