Seq Lane Step - Korg modvawe Owner's Manual

Motion Sequencing 2.0

Seq Lane Step

Step
[A1...D16]
See "Step" on page 37.
Type
[Value + Continuous Mod, Value * Random +/-, Value * Random +, Value + S & H Mod]
Value + Continuous Mod: The Step uses the programmed value, and modulation continuously affects the value. For
instance, if an LFO is modulating Value, you'll hear the LFO's shape during the step.
Value * Random +/-: The Step's Value is scaled by a bipolar random amount. The result may be either positive or
negative.
Value * Random +: The Step's Value is scaled by a unipolar random amount. If the Value is positive, the output will be
positive; if the Value is negative, the output will be negative.
Value + S & H Mod: The Step uses the programmed value, and modulation is updated only at the start of the Step. For
instance, if an LFO is modulating Value, only the LFO's amplitude at the very start of the step matters; you will not
hear the LFO's shape during the step.
Value
[-100...100%]
This sets the output level for the Step.
Transition
[Off, Lin, Exp, Log]
This controls the transition from this step to the next step: whether the value changes abruptly at the next step, or
glides to the new level.
This applies only if the Shape Lane Transitn parameter is set to Indv (Individual).
Off: The value will change abruptly at the next step.
Lin: The value will glide linearly to the next step, as if you were moving a knob continuously. This is the default.
Exp: The value will glide to the next step, with most of the change at the end of the glide.
Log: The value will glide to the next step, with most of the change at the start of the glide.
Probability
See "Step Probability" on page 35.
43