Installing A Module: 8306 And 8310 Chassis - Nortel 8300 Series Installation And Commissioning Manual

14 Installing the chassis
The 8306 chassis provides four slots for installing interface modules and
two slots for installing switch fabric modules. Slots are numbered from the
top down.
For more information on module installation, see Nortel Ethernet Routing
Switch 8300 Installation — Modules (NN46200-305).
"Installing a module: 8306 and 8310 chassis" (page 14)
of the modules in the 8306 and 8310 chassis.

Installing a module: 8306 and 8310 chassis

You can install an Ethernet Routing Switch 8300 module with the power
on or off.
To install an Ethernet Routing Switch 8300 module:
Step
1
2
3
4
5
6
7
Copyright © 2005-2006, Nortel Networks
.
Action
Locate the slot where you want to install the module.
Remove the filler panel or cover. To remove the module filler panel,
see "Removing a module or power supply filler panel" (page
Make sure that the insert/extract levers are extended away from
the front of the module.
Slide the module into the slot using the slot module guides.
Slide the module into the chassis until its connector panel touches
the chassis back panel.
Rotate the insert/extract levers to seat the module backplane
connectors.
Using a Phillips screwdriver, tighten the 2 captive screws to secure
the module to the chassis.
Nortel Networks Ethernet Routing Switch 8300
Installation and Commissioning — Quick Start
NN46200-100 02.01 Standard
3.0 6 September 2006
—End—
shows the location
10).
Nortel Networks Confidential