Garmin G1000 Pilot's Manual page 64

PRIMARY FLIGHT DISPLAY
Load Arrival
Load Arrival allows the pilot to select a published
standard terminal arrival route (STAR) for the destination
airport or replace a current arrival with a new selection.
NOTE The PROC key can also be used to load a
:
departure, an approach, or an arrival.
NOTE: When adding an arrival to an active flight
plan, the pilot may need to remove a duplicate
destination waypoint from the flight plan list.
To select an arrival for a direct-to or flight
plan destination airport:
1. From the Flight Plan Window, press the MENU
key to display the page menu options.
2. Turn the FMS knob to highlight 'Load Arrival',
then press the ENT key. A window appears
listing the available arrivals for the destination
airport.
Turn the FMS knob to select the desired arrival,
3.
then press the ENT key. A window appears
listing available transitions for the arrival.
4. Turn the FMS knob to select the desired transi-
tion waypoint, then press the ENT key.
5. A window may appear listing runways for the
arrival. Turn the FMS knob to select the desired
runway, then press the ENT key.
NOTE: The runway window is not displayed for
every arrival. 'ALL' may appear in the runway
field, indicating that the arrival procedure
applies to all runways. For airports with parallel
runways,'B' may appear at the end of the runway
designation to indicate that the arrival procedure
applies to both runways.
6. With 'LOAD?' highlighted, press the ENT key.
2-36
instrument approach for the destination airport, or replace
the current approach with a new selection.
Garmin G1000 Pilot's Guide for Beechcraft 58/G58
Load Approach
Load Approach allows the pilot to select a published
To select an approach for a direct-to or
flight plan destination airport:
1. From the Flight Plan Window, press the MENU
key to display the page menu options.
Turn the FMS knob to highlight 'LoadApproach',
2.
then press the ENT key. A window appears list-
ing the available approaches for the destina-
tion airport.
Turn the FMS knob to select the desired
3.
approach, then press the ENT key. A window
appears listing the available transitions for the
approach.
4. Turn the FMS knob to select the desired transi-
tion or vectors, then press the ENT key.
NOTE: The 'Vectors' option assumes that the pilot
will receive vectors from ATC to the final course
segment of the approach.
5. With 'LOAD?' highlighted, press the ENT key
to load the approach.
6. To activate the approach, turn the large FMS
knob to highlight 'ACTIVATE?', then press the
ENT key.
NOTE: 'LOAD' adds the approach to the flight
plan without immediately using the approach
for navigation guidance. This allows the pilot to
continue navigating the original flight plan until
cleared for the approach, but keeps the approach
available for quick activation when needed.
'ACTIVATE' adds the approach to the flight plan
and begins navigating the approach course.
190-00629-00 Rev. B