Table of Contents
Advertisement
Front Panel Operation
Front Panel Operation, cont'd
The Annotator Menu System
The Annotator can be configured using the menu system, via the Extron Simple
Instruction Set (SIS
the Extron software program, SPPCP.
N
The Annotator has six front panel configuration menus: User Presets, Input
Configuration, Output Configuration, Advanced Configuration, View Comm Settings.
A hidden menu (Edit Comm Settings) is also accessible
board is installed a scan converter configuration menu becomes available.
Input
User
Menu
Configuration
Presets
Overview of menus
User Presets
This menu allows the user to save the current image settings to a preset number
(1-16), and recall any saved preset to become the current image settings. Each input
has sixteen user selectable presets.
Input Configuration
This menu allows configuration of the following setting for any selected input:
Input type, film detection, vertical and horizontal start points, pixel phase, the
number of total and active pixels and the number of active lines.
Output Configuration
This menu allows configuration of the following settings for the active output:
Resolution and Refresh rate (see table on page 3-8), Output Type, and Sync Polarity
(where applicable).
Advanced Configuration
This menu allows advanced configuration of the following Annotator settings:
Auto Image, Auto Memories, Input EDID (see table on page 3-8), RGB Delay,
Switch Effect, Test Pattern, MTP Pre-Peaking, Internal Temp (view only), Calibrate
Panels, and Reset to Factory defaults.
View Comm Settings
This menu allows the user to view the following serial and IP settings for the unit:
Serial port baud rate, MAC address, DHCP (Dynamic Host Configuration Protocol)
setting, IP address, Subnet Mask address, and Gateway address
N
Edit Comm Settings (hidden)
To display and enter this menu, press and hold the Detail and Color/Tint buttons
simultaneously and then press Next. The hidden menu appears.
This menu allows the user to edit the following serial and IP settings:
Serial port baud rate, DHCP mode, IP address, subnet mask, and gateway address.
Exit Menu
At this menu pressing Next exits the Menu system and returns to the default cycle.
Scan Converter Configuration
This menu, displayed only when the optional scan-converter board is installed,
allows the user to configure the settings for scan-converted outputs.
3-4
Annotator • Front Panel Operation
) of commands through an RS-232 or LAN connected PC, or via
™
For SIS commands
and
SPPCP configuration
Output
Menu
Menu
Configuration
Configuration
These settings can not be edited from within this menu. See next section.
methods see chapters 5 and 6.
.
If the optional Scan Converter
Advanced
View Comm
Menu
Settings
Exit Menu
Menu
Press NEXT
Scan Converter
Configuration
Optional
Advertisement
Table of Contents
