Table of Contents
Advertisement
Unit Name field
The Unit Name field contains the name used as the "from" information when the
Annotator e-mails notification of its failed or repaired status. This name field can
be changed to any valid name, up to 24 alphanumeric characters.
N The following characters are invalid in the device name:
+ ~ , @ = ' [ ] { } < > ' " ; : | \ and ?.
DHCP radio buttons
The DHCP On radio button directs the device to ignore any entered IP addresses
and to obtain its IP address from a Dynamic Host Configuration Protocol (DHCP)
server (if the network is DHCP capable).
The DHCP Off radio button turns DHCP off. Contact the local system
administrator to determine this control's setting.
IP Address field
The IP Address field contains the IP address of the Annotator. This value is
encoded in the unit's flash memory.
Valid IP addresses consist of four 1-, 2-, or 3-digit numeric subfields separated by
dots (periods). Each field can be numbered from 000 through 255. Leading zeros,
up to 3 digits total per field, are optional. Values of 256 and above are invalid.
The factory-installed default address is 192.168.254.254, but if this conflicts with
other equipment at your installation, you can change the IP address to any valid
value.
N IP address changes can cause conflicts with other equipment. Only local system
administrators should change IP addresses.
Gateway IP Address field
The Gateway IP Address field identifies the address of the gateway to the mail
server to be used if the device and the mail server are not on the same subnet.
The gateway IP address has the same validity rules as the system IP address.
Subnet Mask field
The Subnet Mask field is used to determine whether the Annotator is on the same
subnet as the mail server when you are subnetting.
"Subnetting — A Primer", in Appendix B, "Ethernet Connection".
MAC Address field
The Media Access Control (MAC) Address is hard coded in the device and cannot
be changed.
Firmware field
This field shows the firmware version number. This field changes only when the
firmware is updated.
Model field
This field shows the model (Annotator) and cannot be changed.
Part Number field
This field shows the Annotator part number (60-968-xx) and cannot be changed.
For more information, see
Annotator • HTML Operation
7-5
Advertisement
Table of Contents
