Replacing The System Board Computer (Sbc) Assembly - Quantum Ultra 610; Removing The Sbc Assembly - Extron electronics Quantum Ultra Series User Manual

Replacing the System Board Computer (SBC) Assembly —
Quantum Ultra 610
The System Board Computer assembly contains the system computer and the two hard
disk drives. This entire assembly can be removed and replaced if necessary.
ATTENTION:

Removing the SBC Assembly

1.
2.
NOTE: It is not necessary to replace the disk drives whenever you replace the SBC.
3.
Quantum Ultra Videowall Processing System • Maintenance — Quantum Ultra 610 Only
• The SBC assembly is not hot-swappable and cannot be replaced while the unit
is operating. Always power off the unit before removing the SBC assembly.
• L'ensemble de composants SBC n'est pas interchangeable à chaud et il est
impossible de le changer durant le fonctionnement de l'unité. Mettez toujours
hors tension le Quantum Ultra avant de retirer l'ensemble SBC.
Shut down the unit and disconnect the power.
Remove the two hard drives from the SBC assembly and set them aside. They are
used with the new assembly (see
page 93).
If either or both drives are functioning adequately, remove them first, then reinstall
them after installing the new SBC.
Unplug the lower fan cable from the 3-pin connector at the right front corner of the
SBC assembly (see figure 93).
Figure 93. Unplugging the Fan Cable
Replacing a Disk Drive - Quantum Ultra 610 on
Fan Cable
96