Table of Contents
Advertisement
Optional input board (HD-SDI/SDI with BNC's shown) connector (input 7)
g
— Connect an appropriate input to the optional board connector.
Output, user interface, and control connections
RGB/YUV-HD BNC connectors — Connect a display to these for RGB or HD
h
component video output.
RGB/YUV-HD 15-pin VGA connector — Connect a display to this for RGB or
i
HD component video output.
RGBHV
R
G
/R-Y
/Y
H/
V
HV
Optional output card (scan converter with BNC connectors shown) —
j
Connect a display to this for composite, S-video, or component video output.
MTP output — Connect a mini twisted pair receiver to this port
k
PS/2 mouse port — Connect a PS/2 mouse to this port for annotation use.
l
Keyboard port — Connect a Microsoft
m
annotation use.
USB A ports — Connect up to twenty touch panel devices (using USB hubs),
n
or a USB mouse and keyboard to these ports.
LAN Ethernet port — Connect the Annotator to an Ethernet LAN or WAN
o
via this RJ-45 connector. Ethernet control allows the operator to control the
processor from a remote location. When connected to an Ethernet LAN or
WAN, the device can be accessed and operated from a computer running a
standard Internet browser. The Link LED lights green when the Annotator
is connected to an Ethernet LAN, and the Act LED flickers amber, indicating
data transmission as the devices communicate.
C
N Do not use standard telephone cables, as they do not support Ethernet or Fast
Ethernet.
Do not stretch or bend cables. Transmission errors can occur.
See chapter 5, "SIS Programmer's
N
and
chapter 6, "Annotator Software"
Remote (RS-232) 9-pin ports — These connectors provides for two-way
p
RS-232 communication. Connect a host computer or control system via a
9-pin D connector
For touch panels, using a NULL RS-232 cable only, connect the touchscreen
to the Annotator via either of the RS-232 comm ports. RS-232 driver
configuration is necessary and can be done using the Signal Processing
Products Control Program. Within the SPPCP program click Help > Contents
for configuration instructions.
The default protocol is 9600 baud, 1 stop bit, no parity, and no flow control.
Ethernet connection indicators — The LEDs marked "Link" and "Act"
q
indicate the status of the Ethernet connection.
RGBS/ RGBcvS video
B
R
G
B
/B-Y
/R-Y
/Y
/B-Y
S
H/
V
S
HV
Do not connect the MTP cable to the LAN port, or connect the LAN cable
to the MTP port.
See Appendix B
for correct cabling.
p
for serial RS-232 or RS-422 control.
RGsB/ Component Video
(Y, R-Y, B-Y)
R
G
B/
/R-Y
/Y
B-Y
H/
S
V
HV
compatible keyboard to this port for
®
Guide", for definitions of the SIS commands
to install and use the control software.
Annotator • Installation
2-5
Advertisement
Table of Contents
