Table of Contents
Advertisement
Annotator Software, cont'd
• Image Capture — Use this section to capture a displayed image to the Annotator
internal memory. Enter a suitable name (maximum 12 characters) and click
Capture.
• Image Recall — Use this section to recall a captured image. Select the desired
image and click Preview to see a thumbnail image on the connected PC or Recall
to show the image on a connected display device. In addition, a displayed image
can be hidden and a captured image can be deleted within this section.
Font tab
The Font tab allows generation and selection of font type used by the Annotator.
Figure 6-8 — The Advanced Settings tab screen
• Font Generation — Use this to generate a font type to use by selecting from the
font Style drop-down list and font style (regular or bold). Select the country
whose font characters are to be used (United States, France, or Germany) and
click Load. Enter a file name for the saved font file in the Save As dialog box and
click Save.
• Font Selection — Within this section select a font to use from the list and click
Apply. If so desired check the Set to Default Font box. To delete a font select it
and click Delete.
For full details on the tabs and using the software, refer to the Help File within
the SPPCP.
Status bar
The status bar appears at the bottom of the SPPCP screen. It displays information
about the application's current status as well as that of the device.
It shows unit connected, connection type (IP address or comm port), current user
permission level (for example, Administrator), and any error information. If
connected via Telnet, then the IP address or unit name of the device are displayed,
and if connected via serial port, the baud rate and port number are displayed.
Error information appears for 5 seconds in the status bar and then is replaced by
connection and device information.
6-14
Annotator • Annotator Software
Advertisement
Table of Contents
