Table of Contents
Advertisement
Scan converter configuration
This menu is available only when a scan converter board is installed.
Within this menu horizontal and vertical image size and centering can be
configured, output format and output standard chosen, and flicker, horizontal, and
encoder filters set.
1.
Press Next to enter the first sublevel, horizontal and vertical size. The current
settings are displayed. (2048 is the default setting)
2.
Rotate the left front panel adjust knob (
rotate the right adjust knob (
3.
Press Next to go the second sublevel, horizontal and vertical centering.
4.
Rotate the left front panel adjust knob (
rotate the right adjust knob (
5.
Press Next to go to the next sub-level (Output Format), or press Next
repeatedly to get to any level. At each level, rotate either adjuster knobs as
needed to change the settings to the desired values:
Output format (S-video/Comp, YUVi, or RGsB)
Output Standard (NTSC or PAL)
Flicker, Horizontal, and Encoder filter values (0 to 3)
6.
When complete press Menu once or Next repeatedly to return to the top level
menu. Alternatively, allow to time out to return to the default cycle.
Setting the Front Panel Locks (Executive Modes)
The Annotator has two levels of front panel security lock that limit the operation
of the device from the front panel.
Executive mode 0 (disabled) — The front panel is fully unlocked. This is the
default setting.
Executive mode 1 (enabled) — The front panel is locked except for input switching,
video freeze, and auto image.
Executive mode 2 (enabled) — The front panel is completely locked. This
mode can only be enabled and disabled using SIS commands. See chapter 5 SIS
Commands for further details.
Enabling or disabling Executive mode 1 from the front panel
N If the Annotator is in Executive mode 0 (unlocked), this procedure selects mode 1
Press and
hold for about
2 seconds.
Figure 3-6 — Turning Executive mode on or off
When either Executive mode is enabled and a front panel action is attempted (other
than input switching, video freeze, and auto image), the LCD displays the status for
2 seconds.
Lock mode 1 can also be enabled or disabled by SIS commands. See chapter 5 for
SIS commands.
{
) to adjust the vertical value.
{
) to adjust the vertical value.
(locked).
If it is in Executive mode 1, this procedure selects mode 0 (unlocks the unit).
BRIGHT
DETAIL
SIZE
/CONT
LCD screen
displays either
COLOR
ZOOM
POSITION
/TINT
/PAN
[
) to adjust the horizontal value, and
[
) to adjust the horizontal value, and
Executive Mode
Enabled
OR
Executive Mode
Disabled
Annotator • Front Panel Operation
3-13
Advertisement
Table of Contents
