Table of Contents
Advertisement
3.
Press the Next button to go to the next setting. If necessary repeat pressing
Next until the desired level is attained. Refer to the table below for adjustable
settings for each signal format.
Input Format
Film Detect
H Start
V Start
Pahse
Total Pixels
Active Pixels
Active Lines
Figure 3-4 — Adjustments possible per signal format
4.
At the desired setting (for example, Horizontal Start on
input #2 with a YUVp/HDTV signal), rotate the right adjust
knob ({) to adjust the settings value as desired (here to 122).
5.
Repeat steps 3 and 4 for each setting as desired.
6.
When complete press Menu once or Next repeatedly to return to the top level
menu. Alternatively, allow to time out to return to the default cycle.
Output configuration
Within this menu an outputs resolution, refresh rate, output signal type, and sync
polarity can be selected and adjusted. Refer to the table below for applicable
resolution and refresh rates.
1.
Press Next to bring up the Resolution submenu. In this submenu, the
resolution and refresh rate can be adjusted.
2.
Rotate the left front panel encoder (
rotate the right encoder (
See table on next
RGB
YUVp/
RGBcvS
YUVi S-vid
HDTV
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
[
) to adjust the resolution value, and
{
) to adjust the refresh rate.
page.
Annotator • Front Panel Operation
DVI
SDI
HD-SDI
X
X
X
X
X
X
X
X
X
X
Input #2
Horz Start 122
3-7
Advertisement
Table of Contents
