Table of Contents
Advertisement
Powering Up
When applying power to the Annotator, the unit undergoes a start-up self testing
sequence (see image below) and then the LCD displays the default display cycle.
Default display cycle
When in use but not in any menu mode, the LCD screen defaults to cycling through
the input/output configuration currently installed. The displayed content may
vary, depending on the input video signal type. See figure 2-3 for a typical default
display cycle.
Apply
Power
10
sec.
Extron
Extron
Annotator
v1.xx
Annotator
3
3
sec.
sec.
All buttons flash in sequence
Loading OSD file
(green, red, amber).
complete
1
sec.
All input buttons
flash consecutively (amber).
Figure 2-3 — Typical Default Cycle
The default display cycle shows the output rate and the refresh rates for the
currently selected input.
Resetting the Unit with the Reset Button
There are four reset modes (numbered 1, 3, 4, and 5 for the sake of comparison
with Extron IPL products) that you can access by pressing the Reset button on the
rear panel. The Reset button is recessed, so use a pointed stylus, ballpoint pen, or
Extron Tweeker to press it.
reset modes.
C
N
Mode 1
Press and hold
the Reset button.
Modes 3, 4, and 5
Press and hold for
3, 6, or 9 seconds.
Figure 2-4 — Resetting the Annotator
Menu and Next buttons
Sorting graphics
v1.xx
files
3
sec.
Boot-up sequence
complete
1
2
Key
= unlit
See the table on the next page
Review the reset modes carefully. Using the wrong reset mode may result
in unintended loss of flash memory programming, port reassignment, or
processor reboot.
The reset modes listed in the table close all open IP and Telnet connections and
close all sockets. Also, each mode is a separate function, not a continuation
from mode 1 to mode 5.
Reset LED flashes once,
twice, or three times.
remain lit.
1
1
sec.
sec.
1
2
60.0kHz
NEXT
MENU
Last active input
button remains lit.
N The input and output rates shown in the default display
= flashing
= lit
cycle may differ, depending on the type of video signal active.
2
1
Apply Power
Release, then immediately
press and release again. Reset
LED flashes in confirmation.
Annotator • Installation
Default Display Cycle
2
Input #2
Output Rate
sec.
1024x768
60.0Hz
75.0Hz
2 sec.
for a summary of the
Release Reset button.
2-7
Advertisement
Table of Contents
